Giveaway: Chop Source Frame Jig Kit! (ends 11pm CST on March 8th, 2015)

Status
Not open for further replies.

Travis

Forum Staff
Top Contributor
XS650.com Supporter
Messages
4,533
Reaction score
1,493
Points
163
Location
Roberts, WI, USA
Update: 3/18/16

This was a popular giveaway last year, so we're doing it again! Here's the 2016 Frame Jig giveaway.

Update: 3/9/15

And the winner is... Rodalgrumm! Congratulations!

Great response to this giveaway! Everyone who entered (qualified entries only) will be receiving a discount code good through April 9th for 15% off everything on www.chopsource.com! Thanks everyone!

Giveaway: Frame Jig Kit from Chop Source! (ends 11pm CST on March 8th, 2015)

chop_source_frame_jig_kit_giveaway_2.jpg


Win a Chop Source Frame Jig Kit!

To enter the drawing just post in this thread! Existing Members Only! You need to have been a registered member before the date and time of this post to be eligible (this will be verified). All entries from members who joined after this post will be ignored. If you are new to the site, register today to be eligible for future member only drawings on XS650.com.

One entry per person (only the first post by each person in the thread will count). You must post before 11pm CST on 3/8/15 to qualify. The winner will be chosen randomly from the qualified entries. Shipping will be covered by Chop Source within the U.S. (members located outside of the United States will receive a $21.50 shipping credit). Winner may also choose to receive a $326.50 store credit ($305 frame jig + $21.50 shipping).

The Standard Frame Jig Kit includes all of the fixtures and hardware you need to get your table-top frame jig started. You need to supply about 21.5' of 2"x3" or 2"x2" tubing (1/8" wall) for the the jig. The frame jig kit bolts together so you can break it down and store it easily when you aren't using it. No drilling or welding required except for the feet. The neck fixture will accommodate rakes from 15 degrees to 60 degrees.

You will receive:

Basic Kit
- Neck Fixture
- Axle Plate Fixture
- Two Base Clamps
- 1018 Mild Steel Neck Cones

Plus:
- Feet Kit
- Internal Center Fixture
- 3/4" Threaded Rods and Spacers.

Chop Source Frame Jig Kit - Standard - $305 value

For complete details of the Chop Source Motorcycle Frame Jig Kit - Standard, and assembly instructions, visit www.ChopSource.com




Good Luck!
 
Status
Not open for further replies.
Back
Top