1. Dismiss Notice
  2. Dismiss Notice
  3. Hey Facebook people... We've created a group for XS650.com members to connect. Check it out!
    Dismiss Notice

Internal throttle and clutch... who's done it?

Discussion in 'The Garage' started by 1lowdiesel, May 28, 2013.

  1. 1lowdiesel

    1lowdiesel XS650 Enthusiast

    Just sitting here at work brainstorming and was wondering who here has done an internal throttle and or clutch? I'm looking at the Demon cycle kit and it seems fairly straight forward.

    I'm more concerned with the internal clutch set up with making sure that there's enough leverage to actually actuate the clutch. I'm going to be doing either 1" or 1 1/4" bars and i love the clean look.

    Kyle
     
  2. Been wondering the same actually. I'll be watching this. Watched a few vids and read a few bits online, doesn't seem too complicated I think.
     
  3. 1lowdiesel

    1lowdiesel XS650 Enthusiast

    Yea I couldn't find any install pics or how-to's.
     
  4. Block59

    Block59 XS650 Member

    13
    0
    1
    SoCal
    Only I have seen are from Exile Cycles, and used on Harleys.
    Spendy, but seems to have worked?
     
  5. rodemyyamaha

    rodemyyamaha XS650 Enthusiast

    54
    1
    6
    Hey... I am putting internal throttle and clutch on mine. Go to a high end bike store and get the two into one cable for stunt bikes for the throttle... perfect fit and all you have to do is make terminators for the carb end. Making my own clutch cable but so far everything is coming together. I will post more and add pics as I get to that point.
    Video here
     
  6. My understanding is that these are one of those things that you don't want to skimp on. Buy the best you can find, running those cables internally can cause massive headaches if they start to fray and or stick.
     

Share This Page