Rear Axle and Bearing Question

[Jerm]

Where can I get bearings that have stock O.D. and a .750"I.D. to take a common .750"axle. Thanks in advance.

 

[inxs]

- stock front wheel bearing...left and right are the same

ID.17mm-OD.47mm-Depth.14mm...6303 2RS​

- stock rear wheel bearing

lhs-ID.25mm-OD.62mm-Depth.17mm...6305 2RS​

rhs-ID.20mm-OD.52mm-Depth.15mm...6304 2RS​

- 0.750in is 19.05mm
- stock forks will only take 17mm axle
- rear left has a spacer inside the bearing you will need to reengineer or leave out, leaving it out will upset the water sealing

- go to your local bearing shop

 

[Jerm]

Bought a boxed swingarm from mule. He has the axle slots opened up to .75" or 19.05mm. Plan on keeping my stock rear wheel. Before i head to the bearing store I want to make sure I have everything straight.
LHS ID 19.05mm OD 62mm Depth 17mm
RHS ID 19.05mm OD 52mm Depth 15 mm

Does that look correct? Do you think such a beast exists?

 

[inxs]

- why dont you enlarge the axle slots to 20mm?

 

[inxs]

- you may need a longer axle to go thru the box section...better measure it up

 

[Jerm]

He sent it powder coated and ready to bolt on (except for this axle dilemma). He has offered to fab another one up for me with the 20mm slots, but that means more $ shipping things back and forth. However, it seems as though that is what is going to happen.....Thanks again for your assistance.

 

[jay760]

Try looking in the yellow pages for bearing suppliers, or go to an engineering shop and ask for help,