XStretchified650
Back in the 650 Saddle
It has been running great. Planned to ride north to camp at the AHRMA races and Rockerbox last weekend. I was due for an oil change so I took care of that the night before. Got up early to adjust the cam chain, set the valve clearances and check the carb tuning before leaving.
After setting the valves and dialing-in and balancing in the carbs it was running fine but not perfect. The tappet noise was louder than before I started. I got out the timing light and saw that the low rpm firing was occurring at about 90 degrees off the mark.
It was pretty obvious that it was not at TDC when I (very meticulously) set the valves.
......Crap. PMA must have spun a bit. No time to deal with it so I left for Wisconsin in the Toyota.
I will be making a woodruff key for my PMA this weekend. Yes...I had used a torque wrench. I am now of the opinion that getting by without a woodruff key is wishful thinking.
XStretchified
After setting the valves and dialing-in and balancing in the carbs it was running fine but not perfect. The tappet noise was louder than before I started. I got out the timing light and saw that the low rpm firing was occurring at about 90 degrees off the mark.
It was pretty obvious that it was not at TDC when I (very meticulously) set the valves.
......Crap. PMA must have spun a bit. No time to deal with it so I left for Wisconsin in the Toyota.
I will be making a woodruff key for my PMA this weekend. Yes...I had used a torque wrench. I am now of the opinion that getting by without a woodruff key is wishful thinking.
XStretchified