cra-z1

Nice tool but the priceo_O

Nothing worse than making a cable and having it break 5 miles from home especially the clutch cable. For a throttle cable your system...

American made? There are a lot of parts on the Indian that are sourced from other countries, but many are made here. HD same story.

I owned two Victory Kingpins when they (Polaris) dropped the line. Value dropped on both of those bikes. At that point I said I would...

I have to admit it's pretty impressive that Saints actually has monitored this thread. Big thumbs up for a great service and helping us...

We can vouch for Saints. We just got the title for another Z1900 I am working on for a friend and it is being converted to an Idaho...

Ya, always good to check for threads sticking out. Only had to grind a few. Most quality spokes thread in just to the end of the nipple.

I remember doing 150 miles on the 73 Xs650 was a big deal back then. As a 19 year old I could leave Minneapolis and 25 miles out you...

Those carb bodies are not the only ones that can be deformed with over tightening. I have heard of that issue with other carbs

I would say the above is true if you over tighten several without constantly checking how far your pulling the rim. I also use a...

I use a torque wrench, I do test for pitch but have found that the pitch is slightly different from outside to inside spokes. Hard to...

I have had quite a few paint sets done by a painter in Portland. I will ship the stuff to him but no way will I trust having it shipped...

The last show I was in (and it will be last) everything went to the HD crowd. Like how can a 2023 HD win best in class.

Forgot about the RD350 18 inch front

You may want to check that size. Pretty sure the front 75 Xs is also a 19 on the front, 18 on the rear. In fact I cant think of any...

Nice, thats one year I like a lot.

Replace your Diaphragm"s with ones from JB industries. No need to buy new carbs. I assume you have a manual, if not thats the first step...