J
Reaction score
8,075

Latest activity Postings About

    • J
      Jan_P replied to the thread Any vintage car guys here?.
      Studebaker's German and Swiss License plates Some Clubmeeting in South Sweden Dont see them often here a couple of years in between
      • 20260607_193420.jpg
      • 20260607_193454.jpg
      • 20260607_193525.jpg
      • 20260607_193556.jpg
      • 20260607_193715.jpg
      • 20260607_193741.jpg
      • 20260607_193835.jpg
      • 20260607_193909.jpg
    • J
      Jan_P replied to the thread Timing/Tuning Help.
      It depends on " Musician's Ear " If your rotor have slipped and the timing marks are off . When you have found TDC try blipping...
    • J
      Jan_P replied to the thread Noisy oil pump.....
      There exists 3 different clutch setups ( if I recall correct ) depending on year model I once got a set of clutch plates that did rub...
    • J
      Jan_P replied to the thread Interesting motorcycles, not XS650.
      You got lucky there $ 2500 is at least $ 1000 maybe $ 1500 to much money for a 40 year old single not stock I don't believe...
    • J
      Aee hhh maybe people will lose jobs .. I picked up a HiFi at $ 25 from a flea market I do that sometimes when it is something i...
      • 1780790047956.png
      • 1780790248609.png
    • J
      Jan_P replied to the thread Melted Ground Wires from Rectifier.
      PMA charging ?
    • J
      Jan_P replied to the thread Noisy oil pump.....
      Did try spin it please look at the setup No control of if rev correct and spinning on the center nut lying on its side Old...
      • IMG_20260606_142202_451.jpg
    • J
      Jan_P replied to the thread Noisy oil pump.....
      Come to think off it Currently have that side off .Because of Gear shifting problems Going out to close engine temporarily ..for...
    • J
      Jan_P replied to the thread Noisy oil pump.....
      Never heard any noise and since it runs in oil .Would be difficult create noise. I have replaced one because scratches from some...
    • J
      Jan_P replied to the thread XS1B Engine Teardown.
      Thank You for this Inspiring. Any signs inside motor why it was parked ..? I can se a wooden engine holder on the bench .That...
      • 1780742978005.png
    • J
      Jan_P replied to the thread GSXR Fork Swap ?'s.
      Some thoughts .. A fork replacement can make sense .Since the ones on XS can be 50 year old designs and if breaks job is...
    • J
      Jan_P replied to the thread The Free "B", a 1971 resto redux.
      OK Thinking out loud The other day I Used a big strong Magnet I believe salvaged from Pioneer Loudspeakers i Damaged with a...
    • J
      Jan_P replied to the thread Stuck Oil Sump Plate.
      I took of my sump plate today Used a rubber mallet on the front edge in a downward motion .and a little at other points in various...
    • J
      Jan_P replied to the thread No Electrical Power XS-2.
      First guess old weak battery. 12.5 V can be low
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      No engine must out not working
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      Better -- pushing the drum inwards with left thumb and turning on the Screw it appears to go better 30 times not sure if all...
    • J
      Jan_P replied to the thread Right now I'm listening to....
      Thank You Would be interesting .. But perhaps wont happen. Getting older . But I have been in the States once.
    • J
      Yes Sir 2 different motors a ) The one with the hole in cases in Storage Spare had the chain break Works fine except the leak...
    • J
      I have a small hole in one block after the chain link broke smashed .The chain outside the seal Cant take picture at the moment...
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      I was able to rotate it on the screw center on star wheel But not consistently sometimes it hit a hard stop the type preventing...
      • 1780562207852.png
    • J
      Jan_P replied to the thread Right now I'm listening to....
      Crossroads
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      Yes Sir and thank you I did that .Turning on the excenter bolt moving it a bit Still not shifting. The star wheel stopped rotate...
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      After thinking and .. I started to google and AI has a possibility to hack in questions Not saying it is the answer but it is...
      • 1780501320275.png
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      Worn Shift Fork ? Would be surprised if gearbox It .can be a bearing somewhere but I replaced these when rebuilding Can anything...
    • J
      Jan_P replied to the thread Hard to Downshift 3-2-1.
      Thank You . Have taken those parts off everything except the star wheel . The neutral detent spring and bolt is off but not...
      • 1780445102937.png
  • Loading…
  • Loading…
Back
Top