jpdevol's latest activity

It's possible one of the float valves didn't fully seat and shut off the fuel once the bowl was full - it happens from time to time -...

With the safety relay bypassed, the solenoid will be able to energize the starter motor, but the bendix gear will not engage (the crank...

That will work.

Fiddly stuff...

MP08 dual output coils - came on CB750 Hondas, etc - will work with points, TCI or PAMCO. Several available sources (including used)...

If it works, that's great! I don't see a problem with the compound ingredients if that's the question - so long as ya don't huff the...

Maybe someone can come up with a complete points plate assy.?:whistle:

The CYL9 @ 130CCA is a little light, but may work:shrug:. Original spec is 12V 14Ah that typically has 190CCA (cold cranking amps)

Saw that, I was wanting to confirm whether it used a mechanical or electronic advance... I do think Dogbunny is right on the PAMCO...

Ah...now I'm on the same page (maybe); yeah, IMO the scoring is a expandable hone thing - beyond the capability of ball hone (finishing...

The coils should be ok, condensers not needed. Pics to confirm please.

What you have there is a points motor that has an aftermarket "transistorized" points replacement thingie. It can be wired just as a...

Thanks! For some reason I didn't read "oil thread", I read "thread class" with oil inexplicably included. Thought we were gonna have a...

I'm using the 1201 with good results on our XS - the 801 would work, but @ 11AH equivalent could be marginal. PS - I also use Shorai...

??🤔:umm:

From our sister site CB750.com https://www.cb750.com/threads/frame-geometry.8085/#post-39413

Buckhorns Forever! :jk::laugh2: Seriously, there must be hundreds of the stock bars hanging on garages throughout AUS; anyone?

The OP has apparently resolved the bar ground issue, but - just for clarity: the dreaded "arcing" through steering stem bearings occurs...

One possibility is that the starter solenoid actuation circuit power - normally on the red/white wire from ignition coils - is getting...

The switch below has engine stop on top (kill sw); that one should disable ignition and the starter circuit (button) when off...

I may not be clear on what is "off" and the starter still operable via the starter button....