Recent content by koyuga

  1. K

    277 pamco

    Left cyl plug removed. Rotate engine watching valves open close. When both valves closed with left cylinder at top and timing marks on generator aligned on T. (can insert feeler Guage between tappet) Oem charging system The bike was running before this. Away Fm bike atm. Will send pix...
  2. K

    277 pamco

    My pamco fried the #2 mosfet(hall effect) sensor and a diode.)(second time occurrence) Had the avionics engineer repair it. Installed the system as per HHB instruction. 1 cylinder TDC. With timing mark on Fire. Aligned both timing marks on mechanical advance on governor. (original governor)...
  3. K

    Pandemonium choppers👍

    Just a shout-out to Daniel at Pandemonium. He went above and beyond for some electronics. Very responsive and helpful. I found him on Hugh's Hand-built whilst browsing. Both these guys topnotch. If not for the fact I live down under would definitely support these guys more. Cheers. This is...
  4. K

    Pamco transistor G1A538 or 61A538

    Can anyone tell me where to get this part. My 277 pamco is fried It's the small transistor bellow the hall effect sensor. Thx
  5. K

    Newbie Pamco issues

    Hi M8. We're you successful getting the G1A538 transistor. I need one. Thx
  6. K

    Timing Chain sprocket tensioner

    Ok thank you. I understand 256 conrods are no longer available. So will 447 rods be ok?? Cheers
  7. K

    Timing Chain sprocket tensioner

    Hi. I'm currently building an engine that has a sprocket type cam chain tensioner. It seems quite serviceable still. The motor is a 5a9 serial number. But possible that PO has changed things. The conrods were 256! I'm only new to these engines so I'm assuming it came like that FM factory...
  8. K

    Rocker shoulder bolts.

    5twins is correct. The sleeve. I'm tapping from top down. I only tried one. Will have another go at the others. I was nervous that maybe the PO may have used some sealant. You never know. Cheers Gents.
  9. K

    Rocker shoulder bolts.

    Been trying to remove the shoulder tubes from my rocker cover. Not sure exact terminology. Been using the socket and hammer method but they don't budge. Scared to go crazy on these things and do damage. should I be using a press. Thought this would be easy enough?? Thx
  10. K

    Can anyone ID these hubs

    Thx everyone. Cheers
  11. K

    Can anyone ID these hubs

    Thx all replies
  12. K

    Can anyone ID these hubs

    Bought these for a 650. Have a yamaha brand on the rear hub.
  13. K

    Pamco with original charging system.

    Thanks. Then that's what I will do. Thx for the reply. Greg
  14. K

    Pamco with original charging system.

    Hi Forum. I am putting together an old special that is a mix of old parts. I have a Pamco installed and I cobbled together a PMA. But purchased an incorrect size stator that the wrecker sold me. So the stator and rotor are rubbing. My mechanic is an old xs guy and said why not use the...
  15. K

    Bs38 CV jetting.

    Great thank you.
Back
Top