Recent content by peterg

+2 for Boyer. Replaced my poorly operating Pamco with Boyer and the bike have never run better.

Thanks

Thanks. What model number Unis did you install? The pleated filters have worked well with the VM35s. Most kits come with them.

I’m looking for readily available (I live in Toronto Ontario Canada) air filters for my VM34 carbs. I bought the kits from Hoos Racing a number of years ago and they included USA made 3”x4” pleated KN clone filters. The filters have been good until one got knocked off when I hit a pothole and...

The rebore was just a half size up to clean up the cylinders.

Not to confuse things but attached is my updated drawing showing the Boyer ignition I installed last year. FYI. The config switch is used to program the M-Unit.

$5,000 OBO Approx. 8,000 km on rebuild Striped and rebuilt 2016-2017 Frame and metal components power coated Motogadget M-Unit Custom wiring loom New lights Mikuni VM34 carbs. Extra jets and needles PMA Top end motor rebuild 2022. Approx. 800 km New pistons Rebore New Boyer Bransden ignition...

BPR7ES (resistor) plugs and LZFH (non-resistor) caps is the combo you need.

Can’t help you with the reg/rec question but I used (aftermarket) stock switches. See attached diagram.

What the? That is a wild looking (and, I imagine, riding) bike. Nicely done!

👍 Trade you! I couldn’t find one with a chrome rim to match the speedo and tach.

The coil I received with my Boyer blue box kit has secondary resistance of 8.54k which is far greater than the specified 2.75k. The primary resistance is as per spec. What concerns should I have with this coil?

Thanks!

I’m preparing to install the Boyer ignition kit. When I rebuilt the top end last winter I installed needle bearings in the camshaft. See below. Is this going to be a problem? The Boyer instruction state that after installing the 8mm stud and rotor from the left and fitting the 8mm spacer...