SoleX

We'll never know ... the PO was a young woman who did not do any maintenance ... so I'm thinking the PO before that or somewhere in the...

The bike belonged to a young women so I'm think'n the PO before that did the hatchet job ... but hey, I know the bike is up to specs now :)

Engine would stall after popping into first gear. Did al the regular fixings but nothing worked. While removing the clutch basket to...

Took me awhile to figure this one out. Increasing rpm did not work. Put it on a stand and rear wheel would not stop spinning when...

After nearly breaking my foot kick'n the bike into life resorted back to minimal battery and starter. To my suprise a 6 Ah battery (130...

You're right ... RTV! Actually it was not to bad. Took the cover off, inspected both oil screens and the head oil supply line ... clean...

Well there it is ... I stand corrected! worked the 4th bolt lose by applying heat and wiggling back and forth with a hand ratched a...

Non whatsoever ... but that doesn't mean the others are not glued in place ... my worst nightmare is to find out that the stuck bolts...

replaced 10 amps with a 15 amp CB ... works fine

Got one but stil need to find 5 mm hex bit that fits ...

That is my actual engine

These are the buggers that will not come lose. The other 3 at the front come lose after using considerable force. I will get me one of...

Tried everything above ... still stuck like the're welded in ...

Took the bike out for a spin ... just tuned the carbs so i figured i would check the sparkplugs for color along the way. Doing about 45...

bolts are back in ... i do have a manual impact driver but it's too big will try either ratched or impact drill ...

Ok guys ... my bad, we're talking about 5 mm allen bolts, not hex. Used the impact driver function on my deWalt but no succes :(. It...

Quick question ... need to remove the clutch cover from a bike i recently acquirred to acces a worn starter gear but several bolts are...