Search results

Buddy Guy world class phrasing

On central stand You can operate the shifting see if it works .. clicks into position maybe need to push the wheel a little .

It is risky test different connections on electronic regulators . It can fry directly . Without telling I believe there is a Transistor in there and if connected wrong gets high power on the wrong side of the transistor . Dont know since they are Shielded Dont have to be disastrous...

Thank you. Perhaps I have mentioned it .But the word was that there was only a handful could do it in Sweden to mid 80 ies or so And in the aero industry I think they used acetylene torch and since aluminum conducts heat .It was a " Sweet Spot " for the temperature To cold nothing...

Puhh ..hh 2 ----Hours 3 drill bits ...did come off Drilling from the side Had to do one more 35 degrees from one and then a cutting diamond disk close to the lock washer trying to get that segment off .Hitting with a chisel counter clockwise and it started moving and came...

An easy start . difficult see a problem there ---the opposite is worse Can look at the spark plugs after a while and see what happens Even if the plugs was black I would not Bother

It looks like that .Not my bike and I don't have the holes in the sprocket And so when sprocket off Not mine again at 10 -11 o clock the broken chain have smashed a small hole outside the seal. The plan was to get the sprocket off take pictures send it to the friend that...

Try half choke or no Choke at all If to rich it wont start

Are you using choke ? sometimes they can have personality I for a while started it kick start 3/4 choke not touching the throttle started first kick hesitant but started. Other times kick it over 2 times ignition off then ignition on full kick first start

When it starts does it run as it should.

No that should be correct ... I would charge the battery as next

Cant get the Nut holding the Outgoing axle sprocket off Motor out off the frame. Have a compressor .Not the strongest but I believe it is good enough rattle gun I put an old chain inside a pipe ca 1 m 3.2 feet ca Put a screwdriver through it locking it .in the pipe wrap it around...

Difficult to start is typically / usually wrong ignition timing Otherwise it would have started on one cylinder. Mostly

Yes If you have a DC variable Power supply They use them in Electronic Labs It has adjustable Volt and Ampere With some wiring and lamps and so you can set up a circuit and power up and se if lamps turns on and so Measure voltage in the test circuit. Be careful, with...

Well you may be right but the parts Schematic for a 81 do have both if we are talking about the same thing 21 and 22 Big corporations have staff saving costs if manufactures many saving $ 2 per bike adds up I would have installed one Unless someone else here Chimes in

What year model is it ?? https://www.cmsnl.com/en-dk/en-dk/yamaha-xs650s-1980-a-usa_model8686/partslist/D-08.html For a 1980 that has the typical 21 22

Another try Yellow is the Nut Red the conical washer Black contact with the Nut Blue contact with the clutch If it is flipped it can be different

Sorry This is a Linux Computer so I dont know how to draw please check this below in a line 12 to 6 the washer is there and is conical if it is flipped 180 degrees around a vertical line it perhaps wont apply pressure The nut applies force at the inner diameter top part 5 and...

I was wrong abut the springs ..there is a washer spring is it sitting the right way ?

OK I will try -- thinking out loud The clutch as it seems have no springs in this sense That means that the outermost nut is tightening it up For the Bearing not to be crushed the basket must hit a fixed stop and the outer washer 7 also Otherwise the tightening could smash it 6...