Search results

Voodoo Vintage Arrow Split tank. 350.00 email: johann_dizon@yahoo.com for more info.

Looking for a set of pentagram mags for my xs. Anybody holding?

Running 1" bars and found a lever I want to run. The issue is it doesn't have an adjuster knob. I was wondering if anyone knew if there are still cables made with the self adjuster as shown in this pic to adjust free play for the xs. Want to run a similar lever like these. Thanks in...

Hey guys, I'm considering about picking up this KustomTech 2-piston caliper in this link and wondering if a 1/2" bore master cylinder would work ok with this? http://cyrilhuzeblog.com/2011/12/29/super-freni-nostalgic-2-piston-brake-caliper/ Here's a pic of my MC. Brembo 1/2" bore...

Looking to get a internal throttle kit for 1" bars. There's quite a few brands out there and not sure if one design/quality is superior over the other These are the one's I'm considering. Looking for suggestions before I pull the trigger. Exile Cycles Posh Thanks, Johann

Brand new Cole Foster Tank. 250.00 shipped in the US. Pictured at the bottom of this picture. Mocked up on my iron head

Looking for a complete set of engine mounts. Thanks in advance. Johann

Looking for a titled frame for a Cafe build. Thanks in advance. Johann

Introducing project BOARDCHOP! The inspiration behind this next build has heavy boardtracker and chopper influences, thus "Board Chop". I must have 30+ drawing mock-ups but the following drawing below is the closest to the look I'm going for in this next build. Runner up designs

I just picked up an 18" SR500 Drum mag on eBay and wanted to find out the best route to adapt to my hardtailed xs650 frame. The wheel I got is bare and will need new bearings, sprocket, axle etc.. Any one know if there are bearings that will fit to the SR mag where I can use my stock 20mm XS...

Looking for a rear 36H drum hub with complete brake hardware, rear axle and spacers. Something in good condition preferably. Thanks in advance. Johann.

I've been on the hunt for a rear 18" rim but couldn't find anything in good condition so I think I'm better off looking for a hub and lacing it to a new rim. So now I'm looking for a 48 rear heritage hub with complete drum brake hardware. Thanks in advance. Johann

Monstercraftsman weld-on Chain Tensioner, Brand new. $75.00 shipped in the lower 48. This same one link

Rich Phillips seat (good condition) and brand new Biltwell seat hinge. 90.00 shipped.

OldSchool Speed Upper Triple Tree Clamp (w/ Riser holes,) Note: You will need new riser hole bushings however. Paid 140.00 Just used for mockup, sell for $80.00 Link

Just used for mockup. Comes with shims to fit 7/8" bars. Paid 95.00, Will let go for 75.00 shipped in the lower 48 states. Mocked up on my springer.

UniPOD Filters (PK-92) Brand new. I.D. 2 1/4″ x O.D 3″ x L 3″ Item Completely washable Black caps, dark gray foam, water-retardant foam element 30.00

Bought these for plans of a 3rd xs650 build but decided to pickup a non xs project so it's up for sale. Never used. They were rebuilt from Oldskool. Check the original thread. I'll sell them for 300 shipped in the lower 48 states...

Brand new 650 central (the good stuff) Exhaust port optimizer. Paid 90.00 will sell for 75.00 shipped to lower 48states.

Pandemonium choppers hotrod exhaust. Paid 189.00 Sell for $125.00 plus the ride Here they are on my bike