Search results

hi all! I’m hoping someone can help with this, I’m in the process of fitting some Mikuni RS36 carbs to my 77D, I was going to use a switch block from an SR500 because it has pull/push cables, the kill switch on the SR works by grounding the coil in the off position, XS ones seem to work the...

There’s been a couple of threads of late about 8 plate clutch conversions, the alto plates are 2.5mm thick, does anybody know if this is the same thickness as the stock 78 - 80 GS1000 clutch plates? My reason for asking is I was thinking of getting a set of the altos but it would end up being...

So I’ve got some TM36 pumpers in transit and have ordered some boots from JBM and my thoughts are now turning to actually fitting them to my bike, their inlet diameter is 55mm, I was just looking at the local Unifilter site and they have a straight filter 100mm in length x 80mm diameter with a...

hi all, I was was just reading through the Minton mods and in the section about forks it says the following - At this point, you have to decide whether you are going to install air caps. If not, purchase a pair of 1976 Yamaha IT400 fork seals and install them in the fork legs. If you are...

Hi al! I just signed up as I have been lurking for a while and thought I should join in the fun, I have a 1977 in roughish but fairly original condition, I have decided to put a PM alternator in it and understand how it is wired but,,,,,, here’s where the newb bit comes in, when I remove the...