Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS650.com?Consider making a donation to help support the site. XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Hello,
This past weekend my 1977 XS650D broke down when I was on a ride where I lost power(couldnt go past 30mph in 5th gear) and oil started coming through the left exhaust.
I anticipate this being caused by Piston Rings, Exhaust Valve issues, or a damaged Piston. To determine which and...
Hello folks,
I've got me heart set on a nice set of TCBros front springer forks. the construction looks super solid from their video, and they come with lots of support in terms of calipers, bar mounts, and all that rigamarole. the trouble is, with all this corona quarantine happening i am...
BS34 carbs
Throttle shaft seal Suzuki part # 13651-51010 SEAL
I replaced the butterfly shaft seals with these Suzuki seals they fit perfectly. Cost a dollar less than the Yamaha seal .....
https://www.partzilla.com/product/suzuki/13651-51010 5twins tip
BS34 mix screws 1mm thick x 3mm I.D...
I had to fish for the tach drive washer on my ‘76 650C so I took the RH cover off. Fished it, out everything back together (save the kickstart), then discovered I tore my old gasket so it started to leak.
Looked like the original so I decided it’s time to replace. Chipped off the old gasket...
Hello everyone. So I go to do the dry fit before I put the gasket on my crankcase cover and the thing won't go on the engine. The left side of the cover (kick start side) goes on but the right side with the tach gear just won't. I figure it has something to do with lining up the gears but it...
I wrapped my stock exhaust and now am putting them back on the bike, 78 standard. There are crushing type gaskets that are just furiating! It's seem that I need to torque the exhaust nuts way too much just too get the flange even close to the head (like 2mm). They are aligned and I assume I need...
So I did an oil change and put in brand new filters today. The guy that owned the bike before me was technically the second owner, I'll say first because he inherited the bike from his father. Anyway, he obviously didnt change the sump filter, and decided glue on a new gasket. I did my best to...