ggggary

so i get the bike up to speed about 3rd or 4th gear and when down shifting i loose power and the bike dies. It is short and abrupt. almost like a clogged carb issue. i took them off to clean them and there was some gunk in them i recently cleaned out my tank and there was a lot of crud in it...

Could not get my timing set Cam was not in the relation that it should have been to my crank. At top dead center it's about at 10 o'clock. Leaving my timing way to advance.Try taking Meet out of the back plate Of my points . Called Gary told me that the guide could have slipped on my Cam...

Here's a question. My soldering tool doesn't seem to get hot enough to solder silver to a four way connector in the headlight assembly as is stock assembly. The connector is for the direction/signal/running lights. Is there different degrees of heat for solder tools? Suggestions?

Hey Thanks for the advice on Front end dampers - got the info necessary (Thanks Gary). One more damper question. Who knows the meaning/significance (if any) of the stamped numbers on the rim of the damper (see pic). Thanks again guys. Shipper out.