pma & pamco

There’s a description of my project bike, in the introductory post I made 26Jul, that I have questions about. The bike came to me basically finished but for the electrics. It was running when I first bid on it (on the NZ equivalent of Craigslist), but it was withdrawn from auction because its...

- delete -

So I'm at the point of tuning my '71 XB1. I was getting a popping exhaust on the left (sooty, dry). I fiddled with the ignition (Pamco) and got a pretty decent idle. However it would eventually slop out and die. I checked my coil, my plug leads, my plugs. All good connections. Plugs are...

Hey there, so i am new the forum, and its been a long time coming...and i am in need of suggestions. I have a '79 that i have chopped into a fun little bobber and have toyed with for some years and have ripped around on and had a blast on. Last summer, i fried the Pamco, which i attributed to...

My custom chopper, 2+ years in the making. Started full stock all-original, barn find. The only thing 100% original left is the clutch lever. :-) 19" total stretch with hard-tail, gooseneck and 45-degree rake custom springer.

My set up: '80 xs650 PAMCO with E-ADVANCE PMA (not hughs,was already installed on motor, but i do have one new in a box for another motor if i need to switch for some reason) BATTERYLESS system dual output coil mikuni vm34s open 1 1/2" exhaust Just finished my bike and it was doing just fine...

Need a little guidance here. Im not getting a charge. Here is some info on my setup: Hughs rephased 277 engine, Pamcopete ignition, Dual coil green monsters, PMA kit from Hugh, running a battery So after the engine rebuild i discovered my charging system was shitty like most...

Ok so I just put in a Hugh's PMA & pamco ignition. Bike starts and runs but when I turn my key to shut it off the lights turn off and the engine still runs. So I have to pull the plugs to get it to stop. I had run it through my key switch but I guess I didn't do it properly...??? Any words of...