Well, I finally got around to finishing off the right side filter, and damn it looks good. It gives a nice unobstructed air flows, much better than pods. My plan on heating and cooling didn't work too well, much to hard to handle all the bits and pieces and tooling trying to press them together, so, I ended up pressing together cold.
Same with the sizing, .020mm press fit was much too much, so after a few tries I got a good fit by decreasing it to about .04mm. And of course my day wouldn't be complete without misplacing parts, I lost the idle mixture screw spring, no idea where I'm going to get one of them from.
All I have to do now is make an identical one for the left carb from that great slab of aluminium I spent yesterday tracking down, and beat up a rear plate. But first I'll make another fuel distributor block to keep the hosing neat and simple.
If I can remember, I'll take lots of pics of the machining and fabrication process and bore you all to tears with them.
Same with the sizing, .020mm press fit was much too much, so after a few tries I got a good fit by decreasing it to about .04mm. And of course my day wouldn't be complete without misplacing parts, I lost the idle mixture screw spring, no idea where I'm going to get one of them from.
All I have to do now is make an identical one for the left carb from that great slab of aluminium I spent yesterday tracking down, and beat up a rear plate. But first I'll make another fuel distributor block to keep the hosing neat and simple.
If I can remember, I'll take lots of pics of the machining and fabrication process and bore you all to tears with them.
Attachments
-
WIN_20221221_14_59_56_Pro.jpg210.7 KB · Views: 120
-
WIN_20221221_14_56_05_Pro.jpg391.5 KB · Views: 125
-
WIN_20221221_14_55_01_Pro.jpg225.4 KB · Views: 128
-
WIN_20221221_14_54_43_Pro.jpg312.5 KB · Views: 122
-
WIN_20221221_14_50_34_Pro.jpg277.6 KB · Views: 119
-
WIN_20221221_14_38_19_Pro.jpg252.3 KB · Views: 111
-
WIN_20221221_14_38_07_Pro.jpg485.5 KB · Views: 107