Drilling and Safety Wiring My Rotor

rick1956

Just a regular guy.
Messages
88
Reaction score
235
Points
33
Location
Edgewood, Washington
I had been thinking about drilling the rotor out for some time now, and finally got down to doing it. The safety tabs on my bolts were overused and basically shot, so they were going to be replaced anyway, so I figured I might as well do the whole shebang. I made a printout of the pattern I got from the site tech section (thanks, guys!), taped it together, trimmed it, and glued it onto the rotor. Lots of center-punching and drilling later, VIOLA! (pronounced wah-lah) I bought new safety tabs for the reinstall, but I changed my mind after I got them and decided to go the safety wire route for something different. I already had safety wire pliers (I think they followed me home in my lunch box many years ago), so I ordered up some safety wire and some drilled stainless steel bolts off Amazon. I think it came out pretty good, and I still have the new safety tabs in case I reverse myself and go OEM...
IMG_0456.JPEGIMG_0458.JPEGIMG_0459.JPGIMG_0460.JPEGIMG_0464.JPEGIMG_0465.JPEGIMG_0466.JPEG
 
Back
Top