Since inxs was so helpful in finding several plans for tube benders, I thought I'd ask about frame jigs. Has anyone build one? Have any good links or plans? Pros and Cons to different styles?
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Frame jig plans
- Thread starter Travis
- Start date
-
- Tags
- fabricating frame jig plans
- on this site is a photo of a jig - no upper mount but you get the idea if you wanted to put one in
http://pages.prodigy.net/man7sell/_wsn/page4.html
http://pages.prodigy.net/man7sell/_wsn/page4.html
- this is a nice story and shows his home made jig too...kev just doesnt know when to stop
http://www.xs650.org.au/kev's turbo.htm
http://www.xs650.org.au/kev's turbo.htm
- also good story...shows his homemade jig...nice post mod for a single carb set-up
http://www.sense.net/~blaine/hardtail.html
http://www.sense.net/~blaine/hardtail.html
That's a good idea for holding the motor mounts in the proper location. It would be good to keep that installed if the frame is going to be powder coated if they send the frame through an oven to burn the old finish and grease off. Using a junk motor works too.
kent_in_kc
Heartlander
kent_in_kc
Heartlander
That laser idea is slick.
Teebs
King of the Ass-Hats
That's a beautiful frikkin hardtail.
kent_in_kc
Heartlander
Yeah it is. Lots nicer than a non-frikkin one. I wonder if its all original or just a stocker with the Frik mod.
Teebs
King of the Ass-Hats
If you look closely at the second pic you can totally see the uber-frikkin mod. It's tight.
