Perhaps needs clarifying
While rebuilding I bought a new shaft as the below. The old one had a little wear
And upon installing I found that the angle between the axle pointing 5 o clock and the 12 o clock was not
90 degrees on the new one .. it was larger
It had the effect that the top " Shark finned " part was to far out transversely and wanted to jump out looking as post
# 11
Since I had the old one the difference was obvious putting them side by side .
I don't remember exactly how and where i clamped it in the vice ... but I adjusted so the angle was right and
the " Shark Finned " part stayed inside
like that
instead of that
While rebuilding I bought a new shaft as the below. The old one had a little wear
And upon installing I found that the angle between the axle pointing 5 o clock and the 12 o clock was not
90 degrees on the new one .. it was larger
It had the effect that the top " Shark finned " part was to far out transversely and wanted to jump out looking as post
# 11
Since I had the old one the difference was obvious putting them side by side .
I don't remember exactly how and where i clamped it in the vice ... but I adjusted so the angle was right and
the " Shark Finned " part stayed inside
like that
instead of that