Mike's Fuel T-fitting

MikeGyver

'80 XS650
Messages
15
Reaction score
0
Points
1
Location
Sac, CA
Hello all. Does anyone have any experience with the brass carb T-fitting from Mikes? I got one today and installed it and it leaks like crazy. I was very careful to insert the rubber grommets squarely so they were flat inside the carb and assembled the carbs and it has side to side movement! I know I can strip the old rubber off my old one and get some fuel line to slide over it but I figured since I had this one I would like to make it work. It looks like it needs 2 additional rubber grommets to actually make it snug.

This looks like a much better alternative

Thx in advance. :thumbsup:
 
i have one of the ones from mikes and i ad to shave the length off each end to get he carbs to line up to get bracket back on ,,it didnt have any leaks .after i did that so i figured it was that .but the one you post link to seems like a better one
 
I have read of people putting fuel line the length of the hole that the 'T' fit's into, then using silicone grease to get the 'T' into the carbs.
 
Back
Top