Mikes xs install 82 650

[SSMotorsports]

Alright so made a thread before on this and I wasn’t too descriptive on what I was needing, I installed the mikes pmd,(full kit with cdi) I’m 100% certain it’s installed correctly and I’m plugged in to the correct spots, now at this point all I can get out of the bike is for it to crank over. I do have all lights functioning properly and even neutral safety light is working. Do I have to wire something else up? I’m completely lost at this point on what to do
(in picture the 6 pin connector had a light blue wire that was my neutral safety switch and the only other wire out of there getting any power is brown but where does it go??) can’t seem to find the correct diagram for this bike I even had some canvas wrapped wires still

 

[Wingedwheel]

What year bike?

 

[SSMotorsports]

What year bike?

Frame says late 81

 

[jetmechmarty]

canvas wrapped wires still

I believe those are the OE stator outputs.

Somewhere on here is a link to the XS650SH manual. If you can’t find one, the ‘82 XS650SJ manual is the same except for the sidestand safety cutout…AFAIK.

 

[Wingedwheel]

https://www.xs650.com/attachments/81_-xs650h_sh-png.116689/
This should be the correct diagram.

 

[SSMotorsports]

Yellow wires are from pmd unit and when plugged into connector in picture below. it wants to start 2this is the plug from the cdi that was supplied by mikes xs, not sure if my wording is correct either. But where do I plug this into? I have no other connectors on the bike available any help is greatly appreciated I’ve looked thru the wiring diagrams and done what I’ve been able to I’m not super electrically inclined.