Any suggestions guys??? The bolt head for the cross brace snapped off....I have a nice snap on easy out set that has finally failed me, I was applying heat as well, no dice.....can these be run with one mount bolt in the carb?
View attachment 238121
Cant exactly see how it looks --- Is the easy out in there
And it depends how experienced you are with hand held drills and impact wrench
I would apply heat and oil and use a Drill with percussive slip clutch ..depending how the fracture surface looks
Drill / Philips or / Flat bit
Punch and hammer ..
Again carefully not damaging more --- patience.
If it is low down one can ,make a bushing with a center hole drilling through that center hole the drill bit will get ruined if the easy out is in there but never mind.
The purpose is getting the rotation for getting it loose
More heat and oil and alternating going counter clockwise should the screw come out.
A drilll press or taking it so shop that has one helps.