What do you do when your carbs don’t match?…Use one

Halftwist

XS650 Addict
XS650.com Supporter
Messages
108
Reaction score
120
Points
43
Location
Montana
I jumped off into the twighlight zone and welded up a two into one manifold tonight. I put the left side carb(bs38) on it and didn’t change any settings. Fired up first kick. Didn’t run great. Upped pilot one and lifted needle clip one. Calmed down to rideable. Took it about half mile. Definitely some tuning still to do and will post back with final settings.
 

Attachments

  • 0DAAC2CB-1FA8-4078-B98D-C6B8F178DBEE.jpeg
    0DAAC2CB-1FA8-4078-B98D-C6B8F178DBEE.jpeg
    354.4 KB · Views: 90
  • 5A750051-C903-4E01-97DB-7A9D110C7A2F.jpeg
    5A750051-C903-4E01-97DB-7A9D110C7A2F.jpeg
    363.7 KB · Views: 88
Might just be the fact I’m using my phone, but in the first pic on your manifold at the 1-2 position it looks like some porosity. Id just hit that down and run another bead over that just to be sure so you’re not chasing your tail with jetting. If it is my eyes and phone not seeing right then disregard what I said haha
 
Might just be the fact I’m using my phone, but in the first pic on your manifold at the 1-2 position it looks like some porosity. Id just hit that down and run another bead over that just to be sure so you’re not chasing your tail with jetting. If it is my eyes and phone not seeing right then disregard what I said haha
Yea not the prettiest welds I agree, was havin trouble with my bottle, but it is all tight. Just don’t X-ray it😜
 
Back
Top