Wiring Diagram: PMA & Boyer Bransden Digital Ignition

[hemliot1985]

I have the three parts listed below to eliminate the battery on my 1978 xs650, but I'm unable to find any wiring diagrams to help determine wire that incorporates all these new components along with Front Lights, Brake Lights, Master Switch, etc.

1.) Boyer Bransden Micro Power Digital Ignition System Yamaha XS650 (SKU: 108-0076)
2.) Boyer Bransden Power Box 3 Phase Battery Eliminator (SKU: 108-0077)
3.) XSCharge XS650 Permanent Magnet Alternator Kit PMA (SKU: 108-0004)

Would the wiring diagram listed below be accurate enough to tie all these new parts into place along with lights & switches?

 

[Its been a long time]

Excuse my pedantry, but details matter. I assume the regulator is a regulator rectifier? There's four AC phases from the alternator?

 

[hemliot1985]

Excuse my pedantry, but details matter. I assume the regulator is a regulator rectifier? There's four AC phases from the alternator?

Yes, it's a regulator rectifier. Just re-looked at the parts. There's only three wires from the alternator.

 

[Its been a long time]

Yes, it's a regulator rectifier. Just re-looked at the parts. There's only three wires from the alternator.

Thought so.

 

[hemliot1985]

SO, this looks like a good baseline to begin wiring all these components together?

 

[AUTOMAN]

That is one messed up schematic!

 

[650Skull]

I have the three parts listed below to eliminate the battery on my 1978 xs650, but I'm unable to find any wiring diagrams to help determine wire that incorporates all these new components along with Front Lights, Brake Lights, Master Switch, etc.

1.) Boyer Bransden Micro Power Digital Ignition System Yamaha XS650 (SKU: 108-0076)
2.) Boyer Bransden Power Box 3 Phase Battery Eliminator (SKU: 108-0077)
3.) XSCharge XS650 Permanent Magnet Alternator Kit PMA (SKU: 108-0004)

Would the wiring diagram listed below be accurate enough to tie all these new parts into place along with lights & switches?

View attachment 368919

Reg/rect needs an earth.

 

[Jan_P]

New to me so I did some googling Not sure I read it right

https://tcbros.com/products/boyer-b...FdJBXEeWF9E8MYageeNwOg7oVnChyyPa3p3Vhv0BTkR9q

These power boxes replace the voltage regulator, rectifier, and capacitor that is usually found in batteryless PMA systems, but provide the "ultra-clean" power delivery required by sensitive digital ignition advance units.

In the Schematic there is something that look as a battery and a Regulator But as I read it the power box contains all
Maybe I misunderstand something here
Not searched more but Boyer usually have instructions on their website