hey guys, im back again, this time looking for a little help. decided to clean the kitchen table by asembling the bottom end of the build, some of you know my plan was to document here the build every tep of the way, but My camera broke, and also life has been WAY overwhelming... so one day I just got a hair up my ass and began the asemembly, now Ive build engines for over 20 years and usualy my memory and a manual is all thats needed, but I thought I should stop where im at (the bottom end sealed with yama bond and some seals instaled), the reason I thought I should stop is, when I disasemble an engine I set it up in order that its almost self evident where all the bits and pieces go, but I have reached this point and I have 4 items that im not sure about,
there is a washer with an impregnated Ruber center, I belive that was ment to go under the clutch pushrod seal, its O.D. and I.D. match up
there is also a wave washer thats so thin and has a large ID small OD and I think illl figure that one out by its only going to fit one place
then there is a clip of wire c shaped
and last but most concerning is a nylon washer with a Oring that fits its outside perfectly.
any help is greatly apriciated, and I do plan on showing the upper end with the xs1 cly,447 pistons,posted head kedo rockers and such,