Dannyh82
XS650 Enthusiast
Degreeing a rephased adjustable cam is beating me so far... can anyone put in simple terms how this should be done? I'm getting centre line of 84 on the inlet, when it should be 103, so assume my method is wrong as I expected it to be nearer. My TDC is 100% correct just the method of degreeing in the cam I don't get...
TDC is set
Measure degree either side of max lobe lift by 0.040
Add both numbers togeather
Devide what it equaled
= lobe centre line
Is this the wrong way for the xs motor? Maybe I'm reading the degree wheel wrong
TDC is set
Measure degree either side of max lobe lift by 0.040
Add both numbers togeather
Devide what it equaled
= lobe centre line
Is this the wrong way for the xs motor? Maybe I'm reading the degree wheel wrong