NerdyNerd
XS650 Enthusiast
Hey all... I'm back.
So I have the engine in and set up.
It starts and idles fine.
Can't find any vacuum leaks with starter fluid.
Jets are stock and the mixture screw is at 2.5 turns out.
I have tried upping jet sizes and dropping with no change but the bike will not go past 2000RPM without just sputtering. When cold it just dies when I give it any gas, when warmed up it will sputter unendingly with any fuel.
I did a teardown and installed new gaskets everywhere.
Any ideas? I have a feeling its timing related at this point and I'll need to tear it apart again.
So I have the engine in and set up.
It starts and idles fine.
Can't find any vacuum leaks with starter fluid.
Jets are stock and the mixture screw is at 2.5 turns out.
I have tried upping jet sizes and dropping with no change but the bike will not go past 2000RPM without just sputtering. When cold it just dies when I give it any gas, when warmed up it will sputter unendingly with any fuel.
I did a teardown and installed new gaskets everywhere.
Any ideas? I have a feeling its timing related at this point and I'll need to tear it apart again.