Im using a wire welder, so the welds arent as pretty as some. I will be floating out the welds with some filler.
2inch. might just be a tad.. um not enough. i bet it clanks when I ride it.
Any one use these hand shifting, clutch settup thing? I might pull it off. Carbs, pipes in progress.
Mr Riggs adapter with banshee rotor, 91' ninja 600 stator and reg/rectifier, capacitor with no battery, Pamco ignition. dropped the front end 2 1/2 in
Im using a wire welder, so the welds arent as pretty as some. I will be floating out the welds with some filler.
745.jpg
I used a tc brothers hardtail and just cutt off what was in the way.
every thing I took off was rusty and trashed. The seat might have looked good on the outside, but it was pure dry rot. The tank was bad inside, pipes
T

Im using a wire welder, so the welds arent as pretty as some. I will be floating out the welds with some filler.

There are no comments to display.

Media information

Album
75' xs cut em up
Added by
Trav101
Date added
View count
565
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top