IMG 19- Locking washer shown with sealant up against sprocket.
IMG 24- Initial picture showing the bearing edge, where the sprocket will seat up against, with no additional washers or seals, just pressure.
IMG 23- 5Twins has helped us out again, by telling us a tip on how to further prevent leaks, hope this picture does his explanation some justice. Don'
IMG 21- Might be a little messy, but an ounce of prevention. . . adding sealant to back of locking washer.
IMG 19- Locking washer shown with sealant up against sprocket.
IMG 18- Note back of retaining nut has a recess, to help tightly seal against locking washer.
IMG 17- Note correct way of installing 36mm nut.
IMG 16- Top view shows space behind sprocket, where it seats up against the bearing, no seals or washers, just metal to metal.
YAM277

IMG 19- Locking washer shown with sealant up against sprocket.

There are no comments to display.

Media information

Album
Front drive sprocket replaced
Added by
YAM277
Date added
View count
598
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top