IMG 46- 1mm washer top left, spacer top center and 2mm washer top right. Followed by 1mm washer before thrust bearing bottom left, thrust bearing bott
IMG 43- Shot Peening applied, if you are worried about the nut falling off.
IMG 44- Additional pic of finished cush spring install.
IMG 45 Finished version of the back of the Primary Drive Gear Gear, showing the new cush springs.
IMG 46- 1mm washer top left, spacer top center and 2mm washer top right. Followed by 1mm washer before thrust bearing bottom left, thrust bearing bott
IMG 47- Axle bearing shown without 1mm washer installed. . . yet.
IMG 48- Another shot showing the 1mm washer(with part number), the spacer and the 2mm washer.
IMG 49- Figured I'd share the part number, for the illusive 1mm washer, that the PO decided not to put back! Ended up paying $5 bucks for it off BikeB
YAM277

IMG 46- 1mm washer top left, spacer top center and 2mm washer top right. Followed by 1mm washer before thrust bearing bottom left, thrust bearing bott

There are no comments to display.

Media information

Album
Cush Springs / Dampening Springs Guide for Replacement
Added by
YAM277
Date added
View count
441
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top