Yoke clamp was bent in the process of trying to load the bike onto my friend's truck when we picked up the bike.
Me 'n the good homies after helping me pull the engine.
Picked up this rad, but crusty, springer for $200 today. I'm not sure I'll use it on this bike, but if I can clean it up, I think it'll be worth the p
Removed the paint to get a better look at this dent. Turns out it's some sort of gash and has been soldered back together... trying to push, pop, and
Yoke clamp was bent in the process of trying to load the bike onto my friend's truck when we picked up the bike.
Thanks to advice from y'all and some folks on Chop Cult, I tried bending it back into shape with a vice while the fork tube was in place. Worked like
9/30/15 Out of order, but this what the bike looked like when I first bought it... sans front end
11/16/15 Bike is stripped down to just the cycle
abyssmaltailgate

Yoke clamp was bent in the process of trying to load the bike onto my friend's truck when we picked up the bike.

There are no comments to display.

Media information

Album
'77 XS650 Chopper Project
Added by
abyssmaltailgate
Date added
View count
568
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top