Recent content by CZ650

  1. C

    E Advancer pin interference

    Also I work on the same block as a grainger who had a 3mm by 5mm stainless pin IN STOCK! So for 80 cents I can just pop one in after work. And I'll have 9 spares
  2. C

    E Advancer pin interference

    Great point. Dodged a bullet there. I had been rotating the engine for other purposes.
  3. C

    E Advancer pin interference

    Awesome. I also found jradvance filed the pin on his bike. But since I like to keep my stock parts I'll give the dremel shank thing a go. Thanks for the tip. P. S.: that thread is gold. Will have to read the rest
  4. C

    E Advancer pin interference

    Im fitting my e-advancer tonight and I'm finding the top pin does not fit deep enough into its respective hole to allow the aluminum advance replacement to slide over. I've trying probing the hole with a pick to make sure nothing is inside but it seems the pin is to long or the slot in the...
  5. C

    safety relay yellow wire

    I know this is a dead post and all, but it's a good one. I can say that when I tied the relay into a PMA wire, it chattered as described above. I foolishly rode it that way anyways and blew the relay out in a day. Currently have the relay bypassed but Im going to try using modern relays to...
  6. C

    Sputtering at low rpms

    Did you figure this out? I have the same issue exactly. Seems like a lean mixture or timing issues but im hesitant to raise my jets again after already moving both up a few steps.
See more
Back
Top