Recent content by Don DDR

Exactly what I was after, thankx,

Oh yes of course. I am doing a street tracker with a ZX1100 front end and the caliper mounts are for 320mm rotors. I can make what ever I need to put the caliper where ever I want, but I would like to mount the largest rotors possible using the stock cast wheel. I like big brakes and I cannot lie,

Bigger the better that will bolt onto an 81 cast wheel? Thanks,

Sorry Randy, no chain guard, thanks for looking at my post,

PM sent

I have a bunch of stuff I am not going to use on my street tracker build. A couple sets of gauges, black and chrome housings, a very nice set of header pipes. Cylinder heads of different quality, rocker boxes- a clean one and a dirty one. 2 side plates, one is nice, left, still has the "special...

Like that alot. Is the swing are longer? What shocks are those?

Is that bad? Haha, I bought a XS to make a street tracker and wont need the stock pipes. I can get you a picture of them Sunday afternoon when I move the bike from storage to the shop. I remember the pipes were very nice but I will have a 2nd much closer look when they are gunna be sold.

I have a nice pair

Anything that can be used for the front in "16 that is cast and close looking to the stock rear? Thanks,

Where did you get those pipes???

Sure this has been asked 100's times, I want to do a tracker build out of a basket I bought today. I would like to rake it, do a different swing arm, and a few other things. Any options for a 16" front wheel? TIA