Recent content by mattgiblin

I forgot the original rear axle - $25

All parts off 1974 Yamaha TX650A Swing Arm and Swing Arm bolt with crown nut – $35 Clutch Push Lever with all hardware and return spring (plastic assembly broken but there)- $12 Driver foot pegs - $20 for the pair (under scrape on one side, comes with bolt on framing and acorn nuts seen here. I...

Thanks little bill, I found this one from inxs. Everything is the same except for the battery, but I think I can just put the capacitor in place of the battery and all else is the same.

This sounds a lot like my setup on my bobbed '74 XS650. I have the TC bros PMA kit and wiring harness, original points and coils/condensors. I am going to replace the battery with a capacitor. Are there any wiring diagrams/descriptions/videos for this setup anywhere?

Are you still looking for the mufflers too? I could package it all if wanted.

Yes I do. It has an aftermarket seat cover that looks great. I will sell it for $40 + shipping, if you need it.

longtallrider, if you are still interested the parts are available. PM me if you want them still.

Leesburg, VA. These are original parts for a 1974 Yamaha TX650A. They were removed from a fully operational and very well running bike. I am keeping the frame, engine, wheels, brakes and front end for a bobber, but all the other parts are available. This is a steal for anyone looking for parts...

Hey guys, thanks a lot. This really helps out. I will give this a go now that I am back. If I get stuck I might call for backup Daddy G.

Hey everyone, I'm new to the forum and taking on a restoration of my 1974 TX650. I installed a PMA charging kit and am in the process of replacing the battery with a capacitor. I am taking out all the old wiring to do this. My question is do I need to keep any of the wires attached to the...