Recent content by Michael xs650

Sweet, thanks for the replies guys. Ill check ebay and see whats out there.

Can I use any type of ignition coil with the Pamco ignition as long as its primary resistance is 2 to 3 ohms, dual output ? I just put an order for one of the ignition coils primarily used off sportsters.

Found the problem. Two exposed wires coming from the pressure switch. Slapped some heat shrink on them and off I went. Thanks for all the replies, you guys are the best !

Here are some pictures of my tail light and switch (don't know if it will help much) I am using 20 amp fuses and they are the blade type. As far as a ground on the tail light I'm not sure.... There are only two wires feeding out of it and one is connected to headlight and ignition, the...

Ok so I followed the diagram from above (thank you detale) and was able to get the switch to work properly. But... like always something goes wrong. My fuse kept burning out... I was able to ride a few blocks at first before the first fuse blew, I replaced it and was only able to go a very...

Whats up guys, I have a tail light problem. When I turn the ignition key my tail light brightens up all the way as if the brake it consistently being pressed. Here is a diagram of how I have it wired. Bike is from 1975. Thanks.

Just uploaded some photos blackbetty.