Recent content by sparky01

lots of grease 0n thread chaser and you will catch most of the chavings ,vac out and the rest will blow out the ex valve .3

look at acme choppers i have one on mine

I do not think so chk your gas cap is it venting

breaking hard splashes fuel from the float bowls flooding it out floats my be to high

Powerdynamo anybody running one

i am intersied in one to i am in TX

i is a 650 and i checked timing and it was retarded re set and tuned the carbs and it runs great thanks all. now the comp. is up to 140-140 i guess the rings are seating

could it be the carbs

Just rebuilt my 81-650 with a new big fin cylinder, new timing chain and at idle you crack the throttle it back fires through the exhaust (2 into 1). As you let the clutch out and give it gas it stumbles and misses until about 1/4 throttle and then it runs fine. When I was installing the...

thanks all i was wondering about the oring

anybody?

bought new big fin cylinder from Mikes and there is no relief for the o'rings at the bottom of the cylinder sleeves. #2 do you use any gasket sealer on the cyl. or head gasket and #3 do you use anything on the head bolts for torquing i am going to use copper washers

got it thanks guys

bought a cylinder kit from mikesxs and the rings that come with the kit do not seem to be marked as to what side is up and ideas

thats it thanks