Search results

90280 04005 00 HVCcycle 6.99 fits many yamahas

Ignition off should read o voltage ignition on you should read bat voltage

Check all your ground wires it is the only thing common to both sides of the 2 ignition circuits

that is why you always see a flat steel washer between the lock and alloy surface .we were taught that at trade school

Fix the crank

yes you can use the original systems

one shot sign painters paint.It is self leveling and should be available at any good paint shop.

Sorry Pete Losing a friend is hard .I can not imagine losing my wife All my thoughts will be with you

Anyone who has worked on triumph twins and Yamaha xs or tx twins Should be able to tell there is no similarity between these engines.The triumph is a twin cam push rod design with vertically split crankcases. The Yamaha is a single overhead cam design with horizontily split crankcases. In the...

Finally someone who actually knows how differentials work

A good Lincoln grease gun can put out 4000 psi. Be careful

I am presently finishing a 71 Triumph 500 Daytona restoration and have started doing an engine rebuild on a friends 68 BSA Lightening engine.Where are you getting the 270 degree crankshaft from

Your explanation of the Hosk Horex connection through Showa makes the most sense.I had never been made aware of Showa being involved in anything other than suspension componentry

You are correct about the W1 it was a BSA A10 which was being built under license by a Japanese company which was purchased by Kawasaki.The connection between Yamaha and Hosk is disputed in some articles and corroborated in others

Mechanic I apprenticed under always said never thread a drain plug back into the hole until you have the wrench in your hand to tighten it.He was also a stickler on clean up after each job and no customers or visitors where allowed in the work area.

Yes you are correct .That clearance indicates very little if any wear.Remember to still check the end gap of your new rings

Why would you use oversize rings in a std piston you are just making extra work for yourself .Oversize rings are intended for a larger bore when you file them to fit properly in a smaller bore they will not be arched correctly and will take longer to seat in properly.We only did this if the...

amen 5twins

Snow sleet and hail 4degrees celsius