Search results

It's not a national publication but still cool to see them putting my XS650 in it. http://www.thebikinglife.com/pdf/dec2012.pdf

I have a polished aluminum fork brace for a 34mm front end, pre 77 I believe. It's in brand new condition. Someone out there has to have an extended front end on an old XS that could use some bracing. Send me a message if you need a photo.

I have my old Natural Cast Aluminum Rear Wheel for sale. I stripped off the black to a natural finish. Also drilled 3 holes in each spoke. Comes with a 31 tooth rear sprocket with chrome bolts. One season on rear sprocket. Asking $50 I'll send a photo if interested

I have a Chrome Rear Disc Brake Caliper and Bracket 4 Sale. Comes with brake pads as well. Ran for 1 season before switching to a HD rear wheel and brake. Ready to bolt on and go (and stop too) Asking $100

Other than the brake stay is there any physical differnce between a drum brake swingarm and one for a disc brake??

If I switch to a points / condenser ignition I can still utilize my electronic ignition coil correct?

I'm looking at coverting a Yamaha Blaster 4 wheeler to being XS650 powered. May be a preetty exciting 4 wheeler to ride.

O/K I'm gettin a little pissed. I've replaced my clutch push rod seal a few times without a problem. Changed it again when I put on new chain and sprockets. Leaked like f-ing crazy. Had a spare so I changed it again same result. What am I doing wrong or what is the secret?? Does it need to be...

Did some searching but didn't find the info I was looking for. Can a rear mag be adapted to run on the front? 1980 XS650 special. I'm building a trike with some of my spare stuff from my chopper build.

Got my single carb intake setup installed / running this week using a HD CV carb with 42 / 180 jetting. Pretty much good to go which really surprised me.

Does anybody know offhand the diameter of the rear disc brake on an XS650?

Does anyone know where i can pick up a inner wheel bearing spacer for a front XS650 mag wheel? I used the one from my old wheel, which I now want to use on another project, on an old Invader mag I set up to run on my current ride? I can find bearings, seals, etc. but not the inner spacer, Thanks!!