Search results

Very good article this about JIS screws , Mr. Maxpete , not many who knew about this,

Ja , takk skal du ha du også.

There is mutch about this on the net, I just made that tool and went ahead, and you need a M8x1,0 fine thread screw. that screw down that tool with use of the threads to the valvetappet adjustment screw in the rocker arm. When you screw down the tool you press down the springs., 2 of them,, 1...

On the net you often read, and you might have experiance yourself ; The most common oil leaks on xs650 are between the jug and head and at the clutch pushrod oil seal under the left side cover. Earlier my xs was leaking oil here by the head gasket. I torqued up all bolts that was affected ,and...

On the net you often read, The most common oil leaks are between the jug and head and at the clutch pushrod oil seal under the left side cover. Earlier my xs was leaking oil by the head gasket. I torqued up all bolts that was affected ,and also changed out the washers covered with rubber with...

Front sprocket oil leak. http://www.xs650.com/threads/oil-leak-around-front-sproket.30483/ And on my 36 mm nut there is a groove mashined , this groove in the nut is very important and must be installed against the sprocket , so the nut can press the sprocket behind the splines on the shaft, in...

Yesterday one carb was flooding , knocked a little on it and it stopped. Let the bike stand night over to dry out with the spark plug air filter removed for that cylinder that flooded.Today it started on first try, and it run perfect and smooth. This winter I have changed the oil seal on the...

The first start , but one carb was flooding, must wait until tomorrow. Have finished installed sucessfully the "poor mans rearset" must contribute the man who wrote this . Mr Farrell Hope https://www.650central.com/fpoor_man%20cafe.htm