Search results

Its pretty clear from the back end, but i guess from the right side angle it might be hard to see. Didn't really think about that side too much when i was doing the mounting, looks like lots of other guys are side mounting the plate and taillight, is there anything illegal about that?

Here's some pics of my 77.

thanks! those pics will be a big help! gonna take this on tomorrow. will post pics of finished product

thanks that helped a bunch. got the proper jets tossed in and it runs like a champ!

did some searching, cant find much discussion about the fender mounting. Have a TC bros hardtail and mounting a 7 metal west fender, have the tc bros fender strut kit. any pics would help. i've got the basic idea, but looking for tips on making it look the best, or easier to install...

hey guys, Almost got my bike ready to go, have a set of VM34's on there stamped 34A 447 they are brand new, says the guy i bought them from, not gummed up or anything. currently running a 180 main, and the bike won't idle, and is dumping a bunch of raw fuel out the exhaust. i'm running...

UPDATE: Found the pieces! they were mixed in with a bunch of styrofoam chunks. Should be good to go, just need to wire it up now. If anyone has a wiring diagram for a complete bike including pamco, that'd be swell

Just checked, no magnets on the backside of that plate. no keyway either. these must be the wrong parts. the guy i bought it all from might have lost them.

I've got a 78 xs, bought in boxes. came with a pamco kit. i've got the plate on the bike, but there is a note in the instructions to install a plate with a washer and shallow nut. i've found 2 in the my boxes that seem to fit on the shaft after you remove the nut and the bushing. pics attached...

Ok, i think i know whats going wrong here now. I cut some spacers to go on either side of the wheel inside the frame, so there is now side to side play in the wheel now. Also used some washers to space on the outside of the frame so that the axle nut doesn't bottom out on the threads. Now...

Big help! thanks! let you know how it all goes asap

Here's some pics

thanks, I added spacers on either side of the wheel to make it a tight fit in between the axle plate like you said. The nut isn't bottoming out though. I ran the nut all the way down the threads of the axle off the bike, and i have about 1/2" threads after the nut. When i put the axle...

Hi guys, I'm building my hardtail and I'm having a problem when trying to get my rear wheel installed. I have all the parts, spacers bearings seals chain tensioners installed, but when you go to tighten up the rear axle, it feels like I can only tighten it so much, but the wheel still slides...

wife's a babe. :thumbsup:

love them tractor flappers!

YUP! thats what i'm talking about! looks like i'm just going to have to bite the bullet and order a set from him. bike looks great, thx

this looks great! i'd like to do the same idea, but stack the pipes on one side, and have a big fat collector with a slash cut on the end all wrapped in black header wrap

I'd buy a set of pre made pipes if they looked cool. I'd make them if i had the ability. just looking to see what's out there for aftermarket that doesn't look stock-ish. Also have an email out about getting a set built. It would be cool to have both pipes come around the right side of the...

Hey guys, I'm looking for a set of pipes for my bobber project. I've checked out great scott, looks like he's done some cool custom work. wondering if anyone else had pics of some other neat looking pipes. So far i've only been able to find the pandemonium pipes for non stock looking...