fastener

Hi. Most of my engine nuts and bolts seem in pretty good condition but have dirty rusty heads and nuts. Would it be a mistake to clean them up on my bench grinder with a wire brush wheel / abrasive pad or would that be okay? I was just wondering about their protective coatings. Cheers

Hi, I'm in the middle of a build right now and I've used the information in this forum many times. Thank-you for all the knowledge shared here! My question focuses on the frame studs like those that are mounts for the top of the rear shocks. I had my frame sand-blasted and powder coated...

Hi, I'm hoping to get a custom seat made, similar to the full length ones Bratstyle made. Can anyone suggest some good ways to secure the seat pan to the bike? The original hinges make the pan too wide so the new one will fit be the same width as the frame rails / loop and I'll be removing the...