-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
plug
-
Custom wiring diagram review needed
Hello all, I've sketched up a wiring diagram for my 1975 XS650B, which is a hardtail chopper project. it has the stock alternator, as well as: a TCBro's reg/reg: http://www.tcbroschoppers.com/regulator-rectifier-yamaha-xs650-points-ignition-models.html. a TCBro's headlight...- Muckroot
- Thread
- alternator battery blinkers coil diagram fuse fuses horn ignitions key magneto plug spark stator switch wire wiring
- Replies: 7
- Forum: The Garage
-
Aftermarket Fuel tank question
This might be a dumb question but I'm looking to eventually buy an aftermarket fuel tank and it has 3 petcock ports already welded into the bottom of it. I will probably be using the two 1/4"NPT fittings for petcocks. My potentially dumb question is what is the best way to seal up the...- 79josh81
- Thread
- fuel gas plug port seal
- Replies: 17
- Forum: The Garage
-
Tacho / Right Clutch Case - help wanted
I don't have an RPM gauge and don't plan on using one. The PO removed the cable complete and put some weird copper plumbing screw in place of the tach drive retention bolt. I know it is smart to keep the hole for testing etc, but I still don't plan on using it. Question: Can I remove the gear...- vincejames
- Thread
- clutch case crankcase gear gear case hole plug rpm speedo tacho
- Replies: 4
- Forum: The Garage