1 inch handlebars

[NobudgetBuilder]

Im converted over to 1" bars and had a few questions. What master cylinder is commonly used on the 1" bar? Also o jad some interest in doing a hydraulic clutch. What are some of the different setups for that. I saw the write Hugh did but could only find pit bike clutch that fot 7/8 bars. Any help would be appreciated.

 

[member3480]

In the past I have used VT VN master cylinders HONDA SUZUKI 750-1100
For a hydraulic you can go two ways. Hugh sells a system and they are even sold on EBAY . Next there are a couple guys on here who change the slave out of the cover and install a hydraulic slave then you just need a master for bars. Both ways you need 1' Master left right for bars. Harley has both also.

 

[NobudgetBuilder]

Thanks for the info. I figured Harley would have what I was looking for just needed the confirmation i guess.