1979 XS 650
I have the title.
Motor was completely rebuilt, all seals gaskets, piston rings, piston sleeves, carbs were replaced.
I had the crank and cam re-phased by Hughs Handbuilt. And installed an electronic ignition.
All controls were replaced. Handle bars are drag bars. The rake was done before I got it but I had my welder check it out and even X Ray it. He know welds better than I do and have it a clean bill of health.
I had the rims and hubs powder coated. And laced up with new spokes (by a professional I tried and failed)
It ran about two years ago then I moved to Houston and haven’t run it. It will definitely need a carb clean and other associated work that is typical with motor that have sat for that long.
Make an offer
I am in Houston, will not ship.
I have the title.
Motor was completely rebuilt, all seals gaskets, piston rings, piston sleeves, carbs were replaced.
I had the crank and cam re-phased by Hughs Handbuilt. And installed an electronic ignition.
All controls were replaced. Handle bars are drag bars. The rake was done before I got it but I had my welder check it out and even X Ray it. He know welds better than I do and have it a clean bill of health.
I had the rims and hubs powder coated. And laced up with new spokes (by a professional I tried and failed)
It ran about two years ago then I moved to Houston and haven’t run it. It will definitely need a carb clean and other associated work that is typical with motor that have sat for that long.
Make an offer
I am in Houston, will not ship.
