I made 2 into 1 intake. I'm using a VM36 carb. The bike starts right up, but the left cylinder is overfeuling. I tried the intake on a different motor with same result. Swapped ignition from left to reght -> same result. Made a different design intake -> same result.
Both intake runners are the same length with no sharp bends.
I'm using this setup:
180 main
6f9 needle
25 pilot
2.5 slide
159 p6 needle jet
Does anybody have a clue what is going on?
Both intake runners are the same length with no sharp bends.
I'm using this setup:
180 main
6f9 needle
25 pilot
2.5 slide
159 p6 needle jet
Does anybody have a clue what is going on?