da evil one
XS650 Addict
o.k...i got the cylinder bore properly measured for my tx and it came out at 75.4. anybody know what overbore that is when i go to buy pistons and rings?
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
75.4mm cylinder bore=what?
- Thread starter da evil one
- Start date
-
- Tags
- engine
1st over is 75.25 mm., plus .05 mm. clearance takes you to 75.3 mm.; that's .1 mm. (.004") too much slop. Your best bet is to get a pair of 2nd over (75.5 mm.) pistons and have the jugs bored to them. Get the pistons first and take them to the machine shop with the cylinders.
da evil one
XS650 Addict
thanks grizld. you are a scholar and a gentleman.
