member42677
XS650 Member
Also just got stuck there at idle and wouldn’t come down for a while.
if I hold the throttle a bit it will stay on and bounce off 2 grand rpm but as soon as more fuel or less is introduced it dies.
Some houskeeping first: did you install the Dynotune needles that came with the kit and clip in the middle? What do you mean by better vacuum?t it’s still doing that same ping just off of 2k
Likely carbs may be out of synch (I'd still check the pick-up coils first)Also just got stuck there at idle and wouldn’t come down for a while.
New needles, had me drill a hole through the lift. I also put in new fuel mixture screws. Defiantly going to go after those coils and check it outLikely carbs may be out of synch (I'd still check the pick-up coils first)
Came back as 716 and 746 roughly so guess its back to good old fun carbs for meLikely carbs may be out of synch (I'd still check the pick-up coils first)
So does it have a miss above 3000 or won't rev past 3000? Does it clear-out at full throttle and rev to 6-7000 ?New info. Carbs all synced and idles great but when it gets going it hits off 3000rpms. Did a little testing and it breaks past that mark with the throttle pinned
I'd be sus here.New needles, had me drill a hole through the lift.
Won’t rev past 3000 and then with full throttle kicks past and hits around 4500 and can keep going as normal. I installed the needle you have on the left. Do not have a timing light.