Tron
Bearded Sheep Whisperer
I have been trying to get my brembo goldline all hooked up, with Pandemoniums bracket kit and am having a few issues.
The forks are I strongly believe 76 xs650 forks, 34mm, which according to dan, do not need a rotor spacer.
Now, these particular forks are a bit funny, as the calliper mounts are on the non-leading side of the forks, when most 34mm are on the leading side.
So my issue is clearance. The brembo hits the spokes on the inside, yet, I seem to not have much room for a rotor spacer..I have ground down the backside of the calliper quite a lot, i have filed all the edges on the inside to just below the pads, yet I still am hitting the spokes..
Again, I think the rotor is off a xs, sr or rd, as the bolt pattern matches, and it has the same offset.
Any advice, suggestions, or anything at all?
The forks are I strongly believe 76 xs650 forks, 34mm, which according to dan, do not need a rotor spacer.
Now, these particular forks are a bit funny, as the calliper mounts are on the non-leading side of the forks, when most 34mm are on the leading side.
So my issue is clearance. The brembo hits the spokes on the inside, yet, I seem to not have much room for a rotor spacer..I have ground down the backside of the calliper quite a lot, i have filed all the edges on the inside to just below the pads, yet I still am hitting the spokes..
Again, I think the rotor is off a xs, sr or rd, as the bolt pattern matches, and it has the same offset.
Any advice, suggestions, or anything at all?