zoomoto
Blinker fluid low
hey guys.
Thanks for all the help previously.
Well...as it goes. You fix one problem only to discover more. Here’s my current set up.
•Pamco with e-advance
•PMA/Capacitor
•uni pods
•pandemonium ya mommas (planing on modifying them for mufflers)
•78-79 bs38s with matching internals
•jbm diaphragms
•145 main, 35 pilot, dropped needle 1 setting, fuel screw 3 out, float level 25
•shimmed throttle shaft bushings to eliminate side to side slop.
Bike idles well but is surging and hanging up. Loves to stay at 3k rpm.
Not sure how I’m lean? Those are big pilots.
Thoughts are:
• timing issue without proper tdc mark (advances properly)
•out of sync (did bench sync with bits and waiting on manometer from a friend)
•recently replaced most o rings on carbs. I’ve been through them a lot.
Any input would be awesome.
I picked up a pair of sudco vm34s I wasn’t planning on installing until this winter along with rebuild.
Thanks for all the help previously.
Well...as it goes. You fix one problem only to discover more. Here’s my current set up.
•Pamco with e-advance
•PMA/Capacitor
•uni pods
•pandemonium ya mommas (planing on modifying them for mufflers)
•78-79 bs38s with matching internals
•jbm diaphragms
•145 main, 35 pilot, dropped needle 1 setting, fuel screw 3 out, float level 25
•shimmed throttle shaft bushings to eliminate side to side slop.
Bike idles well but is surging and hanging up. Loves to stay at 3k rpm.
Not sure how I’m lean? Those are big pilots.
Thoughts are:
• timing issue without proper tdc mark (advances properly)
•out of sync (did bench sync with bits and waiting on manometer from a friend)
•recently replaced most o rings on carbs. I’ve been through them a lot.
Any input would be awesome.
I picked up a pair of sudco vm34s I wasn’t planning on installing until this winter along with rebuild.